Hi,
This is probably very straightforward but I just cannot find the option. Maybe I'm just tired.
Our server (SBS 2011) currently has two 7.2k SATA hard drives. One for OS, one for DATA. Very simple setup.
I am planning to upgrade both...
OS drive to a 15K SAS
DATA to a 10K SATA
My plan is:
- run a full backup with bare metal recovery enabled
- power down the server and swap over the drives
- boot up recovery media and restore the backup to new drives.
Question:
How can I choose which partitions get restored to which drive?
I have recovered in the past but always from SATA to SATA and I simply make sure the drives are in the same port (eg. SATA0 = OS, SATA1 = DATA). Since I'm going from SATA to SAS this logic won't work.
Thanks in advance for any advice.